24
HOW TO MAINTAIN THE EXERCISE BIKE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the exercise bike is used.
Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent.
IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
INCLINE SYSTEM TROUBLESHOOTING
If the exercise bike does not move to the correct incline
or decline level, see step 3 on page 22 and calibrate
the incline system.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, first
press the power switch
to the off position and unplug the power cord.
Then, use a flat
screwdriver to remove
the Shield Cover (10)
from the exercise bike.
Next, remove the four #8 x 1/2” Screws (95) and the
Electronics Shield (98). Then, locate the Reed Switch
(35), and
loosen
the two #8 x 19mm Tek Screws (97).
Next, rotate the Crank Pulley (53) until a Pulley
Magnet (55) is aligned with the Reed Switch (35).
Slide the Reed Switch slightly toward or away from
the Pulley Magnet. Then, retighten the #8 x 19mm Tek
Screws (97).
Plug in the power cord and press the power switch to
the reset position. Rotate the Crank Pulley (53) for a
moment. Repeat these actions, if necessary, until the
console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the electronics shield and the shield cover. Then, plug
in the power cord.
10
97
55
95
53
98
35
MAINTENANCE AND TROUBLESHOOTING
