10
9
10.
Untie and discard the wire tie on the Main
Wire (110).
While a second person holds the Console (7)
near the Upright (4), plug the Main Wire (110)
into the receptacle on the Console.
The connector on the Main Wire (110) should
slide easily into the receptacle and snap into
place with an audible click.
If the connector
does not slide easily into the receptacle, turn the
connector and try again.
Insert the excess wire into the Upright (4) or into
the Console (7).
Tip: Avoid pinching the Main Wire (110).
Attach the Console (7) to the Upright (4) with
four M4 x 16mm Screws (101);
start all the
Screws, and then tighten them.
9. Apply grease to one of the Pedal Arm Axles (64).
Insert the Pedal Arm Axle (64) into the Right
Upper Body Leg (60) and the Right Pedal Arm
(58) from the direction shown.
Next, slide an M8 x 22mm Washer (129) onto an
M8 x 13mm Screw (82), and tighten the Screw a
few turns into the Pedal Arm Axle (64).
Then, tighten both M8 x 13mm Screws (82) at
the same time.
Repeat this step on the other side of the
elliptical.
82
82
129
60
64
Grease
58
10
Avoid pinching the
Main Wire (110)
7
101
4
110
101
