13
14
47
38
38
C
35
14.
IMPORTANT: Identify the idler roller assembly
(C). To avoid scratching the Walking Platform
(35), do not remove the protective materials
from the Right and Left Rear Feet (45, 46)
until this step is completed.
Carefully slide the idler roller assembly (C)
between the Walking Belt (36) and the top of the
Walking Platform (35).
Then, remove the protective materials from the
Rear Feet (45, 46).
13. Raise the Walking Platform (35) to the storage
position (see HOW TO FOLD THE TREADMILL
on page 25).
Next, orient a Belt Guide (38) as shown, and
set it over the M4.2 x 13mm Screws (5) that you
started in step 10.
Slide the Belt Guide toward
the center of the Walking Platform (35) as far
as the Screws will allow. Then, firmly tighten
the Screws.
Attach the other Belt Guide (38) as described
above.
Then, lower the Walking Platform (35) (see HOW
TO LOWER THE TREADMILL FOR USE on
page 25).
36
35
48
45
46
5
15
12
7
12
7
35
49
15. Pull the Roller Bracket Pins (49) and rotate the
Right and Left Roller Brackets (47, 48) to a verti-
cal position as shown.
Next, slide the Right and Left Rear Feet (45, 46)
onto the Walking Platform (35);
avoid scratch-
ing the surface of the Walking Platform.
Attach the Right and Left Rear Feet (45, 46) with
four M8 x 38mm Bolts (7) and four M8 Nuts (12).
47
45
48
49
46
13
