30
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first unplug the power adapter.
Next, remove the
four indicated
M4 x 16mm Flat
Head Screws
(101), and then
remove the
Lower Rear
Shield Cover
(68).
Next, turn the Large Pulley (21) until a Pulley Magnet
(121) is aligned with the Reed Switch (116). Then,
slightly loosen the M4 x 19mm Screw (113), slide the
Reed Switch slightly closer to or away from the Pulley
Magnet, and retighten the Screw.
Then, plug in the power adapter and turn the Large
Pulley (21) for a moment. Repeat these actions, if
necessary, until the console displays correct feedback.
Then, reattach the lower rear shield cover.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belts may need to be adjusted. To adjust the drive
belts, first unplug the power adapter.
Next, remove the
four indicated
M4 x 16mm Flat
Head Screws
(101), and then
remove the
Lower Rear
Shield Cover
(68).
Then, locate
the lower
Adjustment
Screw (B).
Tighten
the lower
Adjustment
Screw four
turns; this will
tighten the Large
Drive Belt (31).
Stand on the trainer and pedal for a few moments.
If the pedals still slip, step off the trainer and locate
the upper Adjustment Screw (C). Tighten the upper
Adjustment Screw two turns; this will tighten the Small
Drive Belt (28).
Stand on the trainer again and pedal for a few
moments. If the pedals still slip, step off the trainer and
tighten the lower Adjustment Screw (B) four turns; this
will again tighten the Large Drive Belt (31).
When you have properly adjusted the drive belts,
reattach the lower rear shield cover.
101
101
101
68
113 116
121
21
101
101
101
68
B
28
C
31
