26
Inspect and tighten all parts of the elliptical regularly.
Replace any worn parts immediately.
To clean the elliptical, use a damp cloth and a small
amount of mild soap.
IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 5 on page 20.
HOW TO CALIBRATE THE RAMP
If the ramp is not functioning properly, the ramp may
need to be calibrated. To calibrate the ramp, press and
hold the 8 Decline button for several seconds until the
test mode appears in the display.
Press the 8 Decline button again. Then, press the
Quick Power Ramp increase or decrease button to
calibrate the ramp. The ramp will move upward and
downward as it calibrates.
When the ramp stops moving, the ramp is calibrated.
Then, press the 8 Decline button repeatedly to exit the
calibration mode.
HOW TO GREASE THE ROLLERS
See the EXPLODED DRAWING near the end of this
manual. If the Rollers (51) squeak when moving on
the Tracks (11), apply a small amount of white marine
grease equally to each Roller. Spread the grease
evenly around the Rollers. Pedal the elliptical until a
thin
fi
lm of grease is distributed along the Tracks; then,
wipe off any excess grease.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted.
To adjust the drive belt,
first
unplug the power
cord.
Use a flat screw-
driver to remove the
Lower Upright Cover
(56).
Next, remove the M4
x 16mm Screw (104),
and then use a flat
screwdriver to remove
the Shield Cover (75).
Then, use a flat screw-
driver to remove the
Front Stabilizer Cover
(8).
Remove all the M4 x 16mm Screws (104) from the
right Disc (71). Then, gently remove the right Disc.
MAINTENANCE AND TROUBLESHOOTING
56
104
104
8
71
104
104
75
