8
If you purchase the optional chest pulse sensor (see
page 23), follow the steps below to install the receiver
included with the chest pulse sensor.
1.
Make sure that the power cord is unplugged.
Remove
the indicated Screw (108) and the Access Door (31).
2. Remove the paper from the adhesive pad on the back of
the receiver (A).
Hold the receiver so the small cylin-
der is near the lower edge of the receiver and is fac-
ing the Console (107) as shown.
Firmly press the re-
ceiver onto the indicated corner of the Access Door (31).
Connect the wire on the receiver to the indicated wire ex-
tending from the Console.
3.
Make sure that no wires are pinched.
Reattach the
Access Door (31) with the Screw (108). Discard the wires
included with the chest pulse sensor.
6.
Make sure that all parts are properly tightened before you use the treadmill.
Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place; the large allen wrench is used to adjust the
walking belt (see page 27). To protect the floor or carpet, place a mat under the treadmill. If there are thin
sheets of clear plastic on the decals, remove them.
107
31
Cylinder
108
Wire
Wire
5. Set the Console Base (101) on the Uprights (97). Thread
four Upright Bolts (76) with four Internal Star Washers
(77) into the Uprights and the Console Base.
Be careful
not to pinch the Wires (not shown) in the Uprights.
Tighten the two Upright Bolts indicated by the arrows
first; then, tighten the other two Upright Bolts.
Make sure that the Left and Right Trays (109, 111) are
pressed into the Console Base (101).
76
77
101
76
77
111
109
97
97
5
77
A
