3.
Attach the Leg Lever Bracket (5) to the Bench
Frame (1) with two M10 x 68mm Bolts (113) and
two M10 Nylon Locknuts (97).
Attach the Weight Tube (25) to the Leg Lever (4)
with an M8 x 58mm Bolt (106), two M8 Washers
(100), a 10mm Spacer (30), and an M8 Nylon
Locknut (96).
Press a 25mm Round Outer Cap (94) onto the
Weight Tube (25).
Lubricate an M10 x 68mm Bolt (113) with grease.
Attach the Leg Lever (4) to the Leg Lever Bracket
(5) with the Bolt and an M10 Nylon Locknut (97).
Do not overtighten the Locknut; the Leg Lever
must be able to pivot easily.
4.
Lubricate an M10 x 78mm Bolt (110) with grease.
Attach the lower hole in the Adjustment Lever (11)
to the Bench Frame (1) with the Bolt and an M10
Nylon Locknut (97).
Do not overtighten the
Locknut; the Adjustment Lever must be able
to pivot easily.
Hold the handle on the Adjustment Lever (11) so
that the upper hole is above the Bench Frame (1).
Slide the M10 x 62mm Flat Head Screw (27)
through the indicated side of the Lever, over the
Bench Frame, and tighten it into the other side of
the Adjustment Lever.
Make sure that the threads
of the Screw show through the Adjustment
Lever. Do not overtighten the Screw.
5.
Attach the Backrest Bracket (7) to the Backrest
Tubes (8) with four M10 x 45mm Bolts (112), four
M10 Washers (99), and four M10 Nylon Locknuts
(97).
Make sure the Backrest Tubes are orient-
ed so that the indicated holes are closer to
the bottom. Do not tighten the Locknuts yet.
6
3
4
4
30
100
25
96
100
94
5
97
113
113
1
Lubricate
Lubricate
106
1
97
27
110
11
5
8
99
99
Holes
112
112
97
97
7