4. Slide the upper end of a Handrail (2) and then the at-
tached Extension Leg (41) into the right Upright (14) as
shown. (Note: As you insert the Extension Leg, it may be
helpful to tip the Uprights [14] forward and tap the
Extension Leg with a mallet.) Tighten two of the four
Handrail Screws (13) into the Handrail.
Refer to the inset drawing. Tighten an Extension Leg
Screw (34) into the right Upright (14) as shown.
Be sure
to push on the head of the Extension Leg Screw
while tightening it.
Attach the other Handrail (2) to the left Upright (14) as
described above.
6. Attach the Storage Latch (12) to the left Upright (14) with
the Latch Spacer (23) and two Latch Screws (88).
Be
careful not to overtighten the Latch Screws.
7.
Make sure that all parts are tightened before you use
the treadmill.
Keep the included allen wrench in a se-
cure place. The allen wrench is used to adjust the walk-
ing belt (see page 13). To protect the floor, place a mat
under the treadmill.
14
13
14
41
13
2
2
4
88
14
12
23
6
5. With the help of a second person, carefully tip the
Uprights (14) down as shown.
Tighten the two Handrail Bolts (15) in the Extension Legs
(41). Refer to drawing 4. Make sure that the four Handrail
Screws (13) are tightened.
With the help of a second person, carefully tip the
Uprights (14) back to the upright position.
15
41
41
14
15
5
6
2
3. Slide a Rubber Ring (74) onto the post on each Upright
(14). Refer to the inset drawing.
Make sure that each
Rubber Ring is turned so the tapered side is facing
the thickest part of the post.
74
74
Post
Post
14
14
3
Tapered Side
34
14
