20
Inspect and properly tighten all parts of the exercise
cycle regularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild soap—
never use alcohol, abra-
sives, or chemicals to clean the exercise cycle.
IMPORTANT: To avoid damage to the console,
keep liquids away from the console and keep the
console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. To replace the batteries, see
assembly step 8 on page 9. If the console does not
display your heart rate when you use the handgrip
pulse sensor, see step 5 on page 16.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, you must first remove the left pedal and the
left shield. Using an adjustable wrench, turn the left
pedal clockwise and remove it. Next, remove the
screws from the left and right shields;
there are three
sizes of screws in the shields—note which size of
screw you remove from each hole.
Then, gently
remove the left shield.
Locate the Reed Switch (21). Turn the Right Crank
Arm (54) until a Magnet (16) is aligned with the Reed
Switch. Next, loosen, but do not remove, the indicated
M4 x 16mm Flange Screw (61). Slide the Reed Switch
slightly closer to or away from the Magnet, and then
retighten the Flange Screw. Turn the Right Crank Arm
Crank for a moment. Repeat these actions until the
console displays correct feedback. When the Reed
Switch is correctly adjusted, reattach the left shield
and the left pedal.
HOW TO ADJUST THE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is at the highest level, the
belt may need to be adjusted.
To adjust the belt, you must first remove the right
pedal and the right shield. Using an adjustable
wrench, turn the right pedal clockwise and remove it.
Next, remove the screws from the left and right
shields;
there are three sizes of screws in the
shields—note which size of screw you remove
from each hole.
Then, gently remove the right shield.
To tighten the belt, first loosen the M10 x 22mm Bolt
(45). Next, tighten the M8 x 38mm Hex Screw (69)
until the belt is tight. Then, retighten the M10 x 22mm
Bolt (45). Reattach the right shield and the right pedal.
MAINTENANCE AND TROUBLESHOOTING
16
21
61
54
45
69
All manuals and user guides at all-guides.com
