10
11. Untie and discard the wire tie on the Main Wire
(77) and the Extension Wire (88).
While a second person holds the Handlebar (14)
near the Upright (4), route the Main Wire (77)
and the Extension Wire (88) through the notch
in the Upright, through the groove in the Pivot
Bracket (17), and through the hole in the center
of the Handlebar (see the inset drawing).
Tip: Avoid pinching the wires. Insert the Pivot
Bracket (17) into the Upright (4). Attach the
Pivot Bracket with two M8 x 63mm Bolts (26)
and two M8 Locknuts (25). Make sure that the
Locknuts are in the hexagonal holes (A).
14
4
11
10
A
17
88
25
26
77
10. Tip: Avoid pinching the wires. Hold the Upright
(4) against the Frame (1). Attach the Upright
with four M8 x 15mm Screws (24). Start all the
Screws, and then tighten them.
Next, orient the Accessory Tray (5) and the
Console Cover (16) as shown.
Tip: Avoid pinching the wires. Slide the
Accessory Tray (5) and the Console Cover (16)
onto the Upright (4). Then, press the Accessory
Tray onto the Left and Right Front Shields
(57, 58).
5
16
4
1
24
Avoid
pinching
the wires
Avoid pinching
the wires
Notch
Hole
Groove
57, 58
