Pro-face PS-600G, Installation Manual

Page: 9 / 14

E-9
„ „ „ „ „
RAS Interface (RAS)
„ „
„ „ „
Ethernet Interface (10BASE-T)
This interface complies with the IEEE802.3 Ethernet communication standard
(10BASE-T). This interface uses an RJ-45 type modular jack connector (8
points).
„ „
„ „ „
CF Card Slot
This slot accepts a CF Card.
„ „
„ „ „
USB Interface (USB1, USB2)
This interface is for connecting USB equipment.
„ „
„ „ „
Expansion Unit Interface 1 (EXT1)
This interface is used to connect a DIO unit.
„ „
„ „ „
Expansion Unit Interface 2 (EXT2)
This interface is a PCMCIA Bus interface.
This is used to connect a PCMCIA unit.
1
9
8
15
Recommended Connector : Dsub 15-pin plug XM2A-1501 <made by OMRON Corp.>
Recommended Cover : Dsub 15-pin Cover XM2S-1513 <made by OMRON Corp.>
Use Jack Screw XM2Z-0073 <made by OMRON Corp.>
when needed.
Pin Arrangement Pin # Signal Condition
1 ALARM-OUT (-) Alarm Output (-)
2 DOUT (-) General Purpose Output (-)
3 RESET-IN (-) Remote Reset Input (-)
4 DIN0 (-)
General Purpose Input 0 (-)*
1
5 DIN1 (-)
General Purpose Input 1 (-)*
1
6 NC No Contact
7 RESERVE Reserved
8 RESERVE Reserved
9 ALARM-OUT (+) Alarm Output (+)
10 DOUT (+) General Purpose Output (+)
11 RESET-IN (+) Remote Reset Input (+)
12 DIN0 (+)
General Purpose Input 0 (+)*
1
13 DIN1 (+)
General Purpose Input 1 (+)*
1
14 RESERVE Reserved
15 RESERVE Reserved
*1 General purpose Input will latch Input Information.(This detects only the DIN circuit's ON
state. OFF is not monitored.)