Confirm the Installation Gasket's Positioning
It is strongly recommended that you use the gasket since it absorbs vibration in addi-
tion to repelling water.
Prior to installing the GP in its metal panel, place the unit on a level
surface with the display panel facing downward and check that the
installation gasket is securely attached to the back of the unit.
Tightening the fastener screws with too much force can damage the
GP's case. The torque necessary to ensure a sufficient seal is 0.5 to
0.6N•m.
Cut a hole in the metal panel according to the dimensions given below
Insert the GP into the panel from the front of the panel.
Unit: mm (in.)
4
Installation
Attach the GP's Installation Fasteners from inside the panel
The following figures show the four (4) insertion slot locations of the fasteners. Insert
each fastener's hook into the slot and tighten it with a screwdriver.
Gasket
Rear of GP
under 4-R2
Panel thickness should be from
1.6mm (0.06in.) to 5.0mm (0.2in.).
GP Unit
GP
Installation
Fastener
(
7.54
)
+0.04
-0
191.5
+1
- 0
141.5
+1 - 0
(5.57 )
+0.04 -0
