Pro-face GC4000 Series, Installation Manual

Page: 14 / 48

14
Eng
lish
Installing and Replacing the RTC Battery
While lithium batteries are preferred due to their slow discharge and long life,
they can present hazards to personnel, equipment and the environment, and
must be handled properly.
NOTE: Replace battery only with identical type: Renata Type CR2032.
To install or replace the RTC battery, follow these steps:
DANGER
EXPLOSION, FIRE, OR CHEMICAL HAZARD
Follow these instructions for the lithium batteries:
 Replace with identical type.

Follow all battery manufacturer’s instructions.
 Remove all replaceable batteries before discarding panel.

Recycle or properly dispose of used batteries.
 Protect battery from any potential short circuit.

Do not recharge, disassemble, heat above 100
°
C (212
°
F), or
incinerate.

Use your hands or insulated tools to remove or replace the battery.
 Maintain proper polarity when inserting and connecting a new battery.
Failure to follow these instructions will result in death or serious
injury.
Step Action
1 Power off your panel.
2 Open the cover to access the backup battery compartment as shown below:
3 Remove the used battery from the compartment.
4 Insert the new battery in the compartment in accordance with the polarity markings in
the compartment and on the battery.
5 Close the cover and verify that the latch clicks into place.