Pro-face GC4000 Series, Installation Manual

Page: 11 / 48

Eng
lish
11
Panel Setup Procedure
Stage Description
1 Check that the installation panel or the surface of the cabinet is flat, in good
condition and has no jagged edges. Metal reinforcing strips may be attached to the
inside of the panel wall, near the panel-cut, to increase the rigidity of the panel.
2 Decide on the installation the thickness of the panel based on the level of panel
strength required: 1.5 mm (0.06 in.) to 10 mm (0.4 in.).
3 Be sure that the ambient operation temperature and the ambient humidity are
within their designated ranges. (When installing the panel in a cabinet or
enclosure, the ambient operation temperature is the internal temperature of the
cabinet or enclosure.)
4 Be sure that heat from surrounding equipment does not cause the panel to exceed
its standard operating temperature
(see GC4000 Series Hardware Manual, ) .
5 When installing the panel in a vertical position, the logo on the panel face must be
on the right side to keep the power connector at the top.