background image

3

ASSEMBLY

Fitting the Feet

• 

Carefully turn the unit upside down. Using the 

four 12mm screws provided, affix the feet to 

the underside of the heater (see right).

OPERATION

• 

Before connecting the appliance to the mains, make sure that all switches are set 

to the “OFF” position.

• 

Insert the plug of the heater into the main socket.

• 

Adjust the thermostat to a desired temperature level.

• 

Turn on the heating element using the two rocker switches on the side panel. They 

will illuminate when the heating elements are on.

• 

The third rocker switch can be used to turn the fan on to circulate warm air in the 

room when the heating elements are 

on (PEL00941 only).

• 

The fan can be used with the 

heating elements switched off to 

help circulate cool air. The switch will 

illuminate when the fan is on.

 

 

 

Note: 

It is normal when the heater is turned on after a period of no use for it to emit 

some odour. This will disappear after the heater has been on for a short time.

USING THE TIMER

• 

Set the time by adjusting the clock wheel in a clockwise direction only, so that the 

arrow points to the current time.

• 

Set the slide switch position to the clock setting.

• 

Set the time periods required for heating by sliding 

the red teeth outwards. Each tooth represents 

approximately 15 minutes.

• 

Sliding the teeth back in to the centre will turn 

the heater off for that period. To run the heater 

continuously set the slide switch to the (I) position.

• 

In position “O”, the timer continues to run but no 

power is fed to the heater.

Reviews: