2
Please read these instructions carefully before starting installation and retain for
future reference.
IMPORTANT SAFETY INFORMATION
NOTE: Before cutting into walls, check that there are no hidden obstructions behind the
mounting surface such as pipes or cables.
1. Isolate the mains power to the lighting circuit.
2. If a new location is being used, fit a standard wall box and install new wiring
following building and wiring regulations.
3. Remove the two mounting screws from where they are stored inside the switch and
remove the two screw cover plugs from the front of the switch.
4. If fitting in an existing location, unscrew and remove the original light switch and
disconnect the wiring from the terminals.
5. Connect the timer switch to the supply wiring using the marked terminal block on
the PCB on the rear of the switch i.e.:
● Brown or red – Live in.
● Blue or black – Live out.
DO NOT
connect neutral wires.
6. IMPORTANT: Set the jumper onto the required load setting.
7. Using the rotary adjuster, set the desired timer delay from 12 seconds to 12 minutes
approx. This adjustment may need further alteration later as required.
8. Replace the switch plate onto the wall box and attach with the 2 screws provided.
9. Restore the mains power and test the operation of the product.
10. If the timing adjustment needs further amendment, switch off the mains power and
remove the switch to gain access to the rotary adjuster. Repeat items 7 & 8.
11. Fit the cover plugs over the screws once adjustments are complete.
INSTALLATION
RISK OF ELECTRICAL SHOCK. ALWAYS ISOLATE THE POWER AT THE MAINS
BEFORE INSTALLING OR MAINTAINING THIS SWITCH.
•
This product must be installed by a competent person in accordance with the
Building Regulations and the current edition of the IET Wiring Regulations
(BS7671).
•
This product is suitable for use with 220-240V~ 50Hz.
•
This product is intended for domestic use only and only in areas not subject to
moisture.
•
This product is for indoor use only.
•
Do not attach to surfaces which are damp, freshly painted or otherwise electrically
conductive such as metallic surfaces.
•
This product is double insulated and does not require connecting to ground.
•
This product is intended as a direct replacement for a standard one-way wall switch
and fits onto a standard wall box using the screws provided.
•
This product will switch loads of up to 0.8A or 300W. Refer to the lighting
manufacturers literature to determine the start up current of inductive loads to
establish the suitability of this product. Minimum load is 5W.
•
If using this product to switch fluorescent lighting, the light fittings must have a high
power factor, otherwise a power factor correction capacitor will be required to be
fitted.
