20
Do not use the 3D settings until you are thoroughly familiar with the plane on low rates.
High rate (3D)
Low Standard/ initial rates
Ailerons 20
deg
16 deg
Elevators 40
deg.
13 deg.
Rudder 45
deg.
25 deg.
Fly the plane on low rates at first.
At high 3D rates,it can be very difficult to fly these models
Use switchable hi / lo rates and / or exponential settings in your
transmitter to make control LESS sensitive around centre of control , for
smoother flight.
The 3D rates are intended only for extreme aerobatics.
16. Quick start guide and hints.
This page is the place to start if you are an experienced builder. It will save you a lot of time.
If you are not an experienced builder, read it anyway, you may not need to go any further.
Hints and notes.
Almost everyone likes to make improvements so here are some hints to improve the plane
and the experience. You will notice that I am very big on redundant systems. Multiple of
everything is the safest way to go.
Use washers and lock washers on the h-stab retaining screws. You can use a little blue
loctite, but too much or using red loctite will probably cause the blind nuts to rip out when
you try to remove the screws.
