13
Rudder tiller;
After the upper hard point has been drilled through with a 9/64 drill, install the tiller bar so
that it is showing the same amount of threads on each side of the rudder. Once the stud is
installed cut the head off with your Dremel.
After the tiller bar is installed, if you need to adjust the position you can do this without
damaging it by double-nutting two 8-32 nuts and use a wrench to turn the stud into the
hard point.
Now install the horns exactly the same distance from the rudder surface. If using the DuBro
horn set for this you should re-drill the horn with a 1/8” bit in a location that is even with the
hinge center line/ Both horns should be drilled at the same point. Then trim the excess from
the horn, leaving at least 1/8” of material at the end.
