1.1
Parking brake is engaged for shipping.
Disengage brake before removing unit from carton
.
Install Upper Handle Assembly to Main Frame using (4)
5/16-18 x 1 1/2” SS. Hex Bolts washers and Lock Nuts
as shown.
Install the one washer on the outside of
the Frame and on the outside of the Upper Handle
with each bolt.
1.2
Slide the hole in the bottom of
Hopper over the impeller shaft and
attach hopper to Frame using the front
two (2) holes in Hopper with two (2) 1/4-
20 x 5/8 Hex Bolts, Washers, and Lock
Nuts, but do not tighten.
NOTE:
the two
(2) Screen Retaining Clips are installed in
the back two (2) holes with two (2) 1/4-20
x 5/8 Hex Bolts, Washers, and Lock Nuts
as shown
but do not tighten
. Center the
Impeller Shaft in the hole in the Hopper.
Tighten all the bolts. From inside the
Hopper, install the 3/8” ID. Flat Washer
over the Impeller Shaft. Insert Agitator
Wire into hole in the Impeller Shaft as
shown. Install Hopper Screen under
Screen Retaining clips previously
installed.
1. Assembly:
3.
5/16-18 x 1 1/2”
Hex Bolts &
Lock Nuts
Impeller Shaft
Front Holes
Inside Hopper
Back Holes
Inside Hopper
Screen
Retaining Clip (2)
3/8” ID. Flat
Washer
Agitator Wire
Upper
Handle
Parking Brake
Control
Panel
#10-24 x 5/8”
Screw (4)
1.3
Install Control Panel with the
Spreader On/Off Assembly and the
Throttle Cable attached to the engine
onto the Upper Handle using four (4)
#10-24 x 5/8” Pan Hd. Screws. Tighten
securely.
Install a washer on the
outside of frame and the han-
dle brace w/ each bolt
Summary of Contents for PS 200 II
Page 16: ...16 14 Notes Printed 1 13...
