Priva B.V.
18
FS Concentrator – installation manual – 1.2
Set the IP-address to the required (Static!) value and press the “Change network configuration”
button. The FS Concentrator will then reboot and after about 2 minutes the new address will
have been activated. Remember the IP-address: it must be entered into the FS Reader Software
while registering the FS Concentrator.
Reset to factory defaults
If the FS Concentrator has been set to a wrong or unknown IP-address, it won’t be available on
the network. This situation can be resolved by means of a jumper on the Printed Circuit Board
(PCB).
Jumper in ‘KEEP’ position.
Jumper in ‘RESET’ position.
Put this jumper in the RESET position and restart the FS Concentrator (Power Off – Power On):
then the FS Concentrator resets itself to the factory default configuration. Please wait two
minutes to allow the FS Concentrator to reset itself.
Switch off the FS Concentrator and put the jumper back to the “KEEP”; then the configuration can
be executed as described before.
Commissioning
The remainder of the installation steps are described in the “FS Reader Software – User
Manual”:
a.
Select the correct Region for the wireless communication signals.
b.
Register the FS Concentrator by providing the serial number and configured IP-
address.
