Assembly Instructions
STEP 3
Starting from the upper horizontal frameworks, attach the
Corner Bracket
and
Extension Bracket
to
horizontal
Framework Bar
with the
Torx Screw
s,
as shown in a
Fig 3.
Again as in case of
Corner Bracket
(Fig 2e),
it is recommendable to insert the
Fabric Holder
temporarily inside the
slot marked by
a)
to ensure it
fitting there also after tightening the
Torx Screw
s of
Extension Bracket.
Make also sure the
Corner Bracket
becomes in contact with the recess edge of
Framework Bar
, as marked by
b)
. Then lift the bar hanging to
the
Wall Socket
s of
Wall Plate
s.
Fig 5
Video Screen
Cinoscreen F-100 / F-AT100
Fig 4
STEP 4
Similarly now built the other side of upper horizontal framework bar, but now first string the
Wall Mount Side
to the
Wall Socket
in side, after which connect the other end to the
Extension Bracket
, exactly as presented in
Step 3.
Finally do the same procedure to the lower horizontal
Framework Bar
s, which are full mirror images for the
upper bars.
STEP 5
Now complete the framework by adding the vertical side and center bars
(Fig 5)
. The side bars are attached to
corner bracket
s with
Torx Screw
s
.
It is important that the side bars are oriented so that the hole on a recess of
both bars are located
on the side of wall
(Fig 5b)
. Again make sure the each
Corner Bracket
becomes in
contact with the recess edge of
Framework Bar
, similarly as with horizontal bars, marked by
b)
in
Fig 3
.
The vertical center bars are attached to horizontal bars by two
Cap Screw
s
m8 x 50.
The bars are oriented so
that the recess is formed to the opposite side of wall as shown in
Fig 5c.
Tighten the all screws securely by
using the
L-wrench, 6 mm.
Still screw the four
Set Screw
s
, m6 x 8
to the screw holes of both upper and lower
Wall Mount
s at location
shown in
Fig 3c
to an extent that prevents the bars falling from the
Wall Socket.
Fig 3
b)
a)
c)
c)
c)
wall
recess
wall
b)
