STEP 6
Now attach the top-right
Framework Bar (Fig 6)
. First string the
Wall Mount Side
to
Wall socket
after which
connect the other end to
extension Bracket
by three
Torx Screw
s
, 5 x 35
. Tighten the screws securely using
Torx Driver
.
Also now screw the
Set Screw, m6 x 8
to the screw hole at location
Fig 5e
to an extent which
prevents the bar falling from the
Wall Socket.
Finally do the same procedure as mirror image for the bottom horizontal framework bars, which are much
similar to the upper bars except for the electrical control boards and wiring they include.
Fig 6
Fig 5
c)
STEP 5
Starting from the horizontal
Framework Bar
at top-left, first attach the
Wall Mount
to
Extension Bracket
by
using two
Cap Screw
s
, m6 x 16 (Fig 5a).
Next using three
Torx Screw,
black
connect the
Extension Bracket
to
the slot of framework bar
(Fig 5b).
After this, by using
Torx screw,
clear
attach
Wall Mount Side
to the pre
assembled corner bracket as shown in
Fig 5c.
Finally string the wall mounts
to
Wall Socket
s of
Wall Plate
s,
exactly as shown in
Fig 5.
By using
L-Wrench, 4 mm
insert and tighten the
Set Screw, m6 x 8
in the screw hole
at location
d)
to an extent which prevents the bar falling from the socket
.
NOTE!
The pre assembled bars, which are assembled in top can be identified not including the electrical control
boards on them.
d)
e)
a)
a)
b)
Assembly Instructions
Masking System
Cinomask F-100
Fig 7
STEP 7
To finalize the masking framework assembly, attach the two vertica
framework bar assemblies to the horizontal bars
(Fig 7)
. In every
four corner use
Cap Screw, m8 x 16
(marked with
a)
in close up),
and two
Cap Screw
s
, m5 x 16
(marked with
b)
in close up). Tighten
the screws securely using
L-Wrench, 5 mm
and
L-Wrench, 4 mm
.
Make sure that after installation
the loosen
wire ends of both
vertical bar assemblies are locating in bottom corners
, so that
they can be further connected to the motor control boards.
STEP 8
Attach the connector ends on left-bottom together as shown in
Fig 8a
.
Make sure the parts snap securely to each other. Now connect the
power for the first time to the socket, marked by
b)
in
Fig 8
. There is an
extra notch on a framework slot under the aluminum bracket
(Fig 8c)
to
offer enough space to feed the DC plug into the socket.
Fig 8
a)
b)
Bottom view
c)
