Masking System
Cinomask F-100
Assembly Instructions
STEP 3
First attach the four velvet stickers exactly as presented in
Fig 3.
All four
stickers are in line right below the bottom horizontal screen framework bar.
The stickers at corners are also in contact with the side wall plates, while the
center ones are separated from the plates with a distance as informed in a
picture. The stickers are for preventing the parasitic reflections of opto-
electrical transmitters of mask travel detection from wall to system, thus
making the performance 100% reliable with all wall materials.
635 mm : 156”
526 mm : 136”
421 mm : 116”
635 mm : 156”
526 mm : 136”
421 mm : 116”
Fig 3
STEP 4
Now attach the total eight
wall Socket
s to remaining screw holes of every four
Wall Plate S (Fig 4a)
and both
two
Wall Plate (Fig 4b).
Tighten the sockets securely and make sure the heels of sockets come in contact with
the plates.
Fig 4b
Fig 4a
Assembly Instructions:
STEP 2
If you are upgrading the
Cinoscreen F-100 / F-
AT100
, remove the
Velvet Frames
from the
Cinoscreen
while it is hanging on the wall. Also
remove all the existing
Frame Holder
s from the
back side of frames and replace them with
Frame
Holder
M
parts. By using
Cap Screw
s
,
clear
m6 x
20,
prepare to attach the new holders to frames
exactly as shown in
Fig 2.
Tighten the screws
securely using
L-wrench, 4 mm.
In the horizontal frames the
screw hole
s of new
frame holders are pointing from center to side,
whilst in the vertical frames only the holder in the
middle is pointing from center to side, and the two
others in side are pointing from side to center.
STEP 1
First unpack the items from shipping tubes and boxes. As shown with an arrows in
Fig 1,
remove the two delivery bars from each horizontal and vertical
Framework Bar
s, which
connect the two bars to each other
.
Use
L-Wrench, 3 mm
for the screws to release the
bars.
screw hole
Fig 2
= Direction to where the screw hole
of part is pointing
Fig 1
