Printronix L7032, Quick Setup Manual

Page: 22 / 50

Install the Fuser Cleaning Roller, Ozone Filter, & Power Cord
22
4. Hold the new fuser cleaning roller (shown in Figure 10 on page
16) by its handles and lower it into the fuser unit.
5. Close the top of the fuser unit.
6. Turn the fuser latch counterclockwise slightly and hold it while
you push the fuser drawer back into the printer. Once the fuser
drawer starts to go into the printer, you can release the fuser
latch. Push the fuser drawer into the printer until it latches.
7. Install the new ozone filter (shown in Figure 10 on page 16) in
the ozone filter opening on the back of the printer. Push it all
the way into the opening. See Figure 16.
Figure 16. Installing the Ozone Filter and Connecting the
Power Cord
8. Make sure the printer's voltage matches the voltage of your
electrical outlet by checking the certification of voltage rating on
the product label. The product label is on the back of the
printer.
9. Connect the AC power cord to the plug on the back of the
printer. See Figure 16 above.
Agency
Label
Indicates
Voltage