Prins Direct LiquiMax, Installation Manual

Page: 4 / 38

PAGE 3 076/0705500
Copyright © Prins Autogassystemen B.V. 2014
Required equipment / tools / materials for installing a complete system
- Complete workshop toolbox ( wrenches, screwdrivers, cutters, pliers, ratchet, sockets )
- Car lift
-
Portable computer
-
Vehicle fuel system scan tool or OBD scan tool Prins ( part nr. 099/99928 )
- Exhaust gas analyser
- Multimeter
-
Oscilloscope
-
Prins diagnostic software
- Prins serial interface
-
Torque wrench ( 5-50Nm )
-
Torque wrench ( 200-250Nm )
- Portable light
- Assortment drill bits 4 to 12 mm
- Assortment cutters ( ø 20, 30, 50, 70 mm )
-
Portable drill or pneumatic drill
-
Thread cutting device ( male M6x1, M8x1, M10x1 )
- Air gun
- Vacuum cleaner
-
Safety goggles
- Hot air gun
- Soldering iron, soldering tin
-
Wire-stripping pliers
-
Adhesive tape
- Adhesive sealant
- Thread locking compound
- Anti-corrosion agent / black body coating
-
Gas leak detection device or foam leak spray
-
Shrink sleeves
Vehicle check
- Check the vehicle drivability on petrol
-
Check the fuel system for error codes ( scan tool )
-
Check if the catalytic converter is in good condition ( exhaust gas analyzer )
- Check the condition of the ignition system ( spark plugs, cables, coil )