Vetronics 760
-3-
3.
UNIT MOUNTING
The unit can be fastened by tightening straps using four mounting points on the unit. A solid "velcro" or double-
sided adhesive tape can be also used to secure the unit. Before bonding, it is important to clean the contact surfaces
from dust, grease, water and other dirt.
Warning: Due to the nature of some unit functions (eg. Driver’s Style Rating), it is essential that the unit is
installed in the vehicle firmly.
3.1. Description of basic parts
The following figure shows the unit from the side and from the top.
3.2. micro SIM card (3FF)
For the proper function of the GSM module in the unit, it
is necessary that the inserted micro SIM card has a deactivated
PIN. You can do this on your mobile phone before inserting a
micro SIM card into the unit.
Open the rear plastic cover of the unit and insert the
micro SIM card into the holder as shown in the illustration.
SIM card contacts must point to the drive. The contact pads on
the SIM card and on the SIM card holder in the unit must be
clean. The correct orientation of the SIM card defines the cut
corner of the card.
Warning: Insert the micro SIM card when the unit is powered off.
3.3. Seal
The rear plastic cover of the unit can be sealed with a special self-adhesive seal depending on the agreement
with customer. The purpose is to avoid any unauthorized interference with the unit.
MCX connector for
GPS antenna
Slot for SIM card is
located under the
bottom lid
Mounting points
Cable harness
connector
Type and serial
number label
Status LED’s
