-10-
u
Item “u=x“ indicates the presence of the UIN1 main power supply and the UIN2 "voltage behind the key" signal
according to the table:
value
UIN1
UIN2
u=0
off
off
u=1
on
off
u=2
off
on
u=3
on
on
A
Item “A=a“ indicates the status of the business/private switch. It can only have two values, either "A = 0" (private
journey) or "A = 3" (business journey).
engprs
If "engprs = g" has a value "engprs = 1", it indicates that the GPRS feature is enabled in the configuration (but
does not say anything about whether the APN is set or whether the service is enabled by the SIM card). "engprs = 0"
means that GPRS configuration is disabled.
alive
Item ”alive=tt“ shows the set time from switching off the ignition until the unit starts sleeping (transition to low-
power mode). The time interval can be expressed in minutes (eg. "alive = 30m") or hours (eg. "alive = 8h"), "alive =
none" means prohibited sleeping.
aux
Item ”aux=app“ indicates the function (application) setting on the service line. An item is listed only when this
function is set. If the correct activity on this line is detected, the brackets are expanded, indicating the time of this
activity in seconds, minutes or hours (eg. (5s), (99m), (24h)). If activity has not been detected (from restart or within
99 hours), "(-)" is displayed. The activity means detecting of data on the line. In case of formatted data, the format
and the checksum of the received message are also checked. For some features the activity is not checked.
trm
Item ”trm=app“ indicates same information as ”aux=app“ just for terminal line.
id
Item ”id=src(t)“ contains information about the driver's log-in source with the most recent login information.
SN, HW a FW
These items indicate the following unit information:
"SN=nnnnnnnnnn" – serial number of the unit
"HW=h.hh" – hardware type of the unit
"FW=f.f.f.f" – firmware version of the unit
fms/obd/vwm/off
This items indicate CAN bus mode settings and examples of recognized information from this bus. The first two
parameters separated by the "/" character include the type of the bus or the application that is set in the
configuration. Behind this item, the information you see is different by the settings. There may be information about
mileage, tank fuel, mileage and time for service, etc.
