AQU
A STROBE
TM
LED
FLASHING EMERGENCY SAFETY
AND RESCUE LIGHT
ENGLISH
Years of trouble free and reliable operations
can be expected if you follow a few simple
instructions and care for the light properly.
Battery Installation -
See Figure 11
• 1AA Alkaline (LR6)
Princeton Tec cares about the environment
and recommends recycling battery. For
more information about battery recycling,
please go to www.batteryrecycling.com.
Observe proper battery polarity. Improper
installation of the battery will damage the
light and void the warranty.
Warning
c
• Always remove drained battery
immediately.
• Remove battery during long periods of
storage.
CAUTION to avoid leakage, do not over
tighten lens cap.
O-RING – Occasionally clean and lightly
lubricate the o-ring and lens cap threads.
Use only silicone grease, never use aerosol
spray lubricants.
WARNING – All plastic components
are made of high-impact resistant
polycarbonate plastic. Certain forms of
aerosol sprays can cause damage and void
warranty.
MAINTENANCE – As with any outdoor
equipment, this light should be rinsed
with fresh water after each day’s use. Avoid
getting dirt and grit in the threads of the
lens cap. If this occurs, take the light
apart, remove battery, and clean threads
with soap and water, lubricate o-ring and
reassemble light.
Operation
- See Figure 2
Turn bezel clockwise to activate the strobe.
Turn bezel counterclockwise to deactivate
the strobe.
Troubleshooting
If the Aqua Strobe LED fails to light:
• Check the battery for proper installation.
• Replace battery if proper installation is
confirmed.
• Check circuit board for water (the seal
may have been compromised by improper
rear cover installation or dirty seal). The
light will resume normal operation once
the water is shaken or blown out and the
light is left open until completely dry. If
the light has been contaminated with salt
water, flush the unit with fresh water and
dry as described above.
USA– International 1-Year Warranty
WARRANTY – Princeton Tec warrants
this product to be free from defects in
workmanship and materials under normal
use for 1 years. This warranty covers all of
the component parts of the product except
batteries. This warranty does not cover
deterioration due to normal wear or damage
due to misuse, alteration, negligence,
accidents, or unauthorized repair. Princeton
Tec will repair or replace parts which are
defective in workmanship or materials.
Your authorized Princeton Tec Dealer
and Princeton Tec are the only facilities
authorized to repair the product. After (3)
unsuccessful attempts (within the warranty
period) to repair the product, you have the
right to elect replacement of the product or a
refund of the purchase price less allowance
for use of the product. NO INCIDENTAL
OR CONSEQUENTIAL DAMAGES ARE
INCLUDED IN THIS WARRANTY. (Some
states do not allow the exclusion or limitation
of incidental or consequential damages,
so the above limitations or exclusions may
not apply to you.) This warranty gives you
specific legal rights, and you may also have
other rights which vary from state to state.
Princeton Tec reserves the right to change
product specifications without notice.
FOR CALIFORNIA RESIDENTS:
WARNING: This product contains Bisphenol
A (BpA) a chemical known to the State of
California to cause birth defects or other
reproductive harm.
Return Policy
- If your light fails to operate, follow these
simple steps:
1. Check battery. Replace if necessary.
2. To send your light in for repair or
replacement, first contact Princeton Tec
customer service on
1-800-257-9080 to
request an RMA number. Please have
your light model, date of purchase and
a brief description of the fault you are
experiencing. No warranty repairs will be
accepted without an RMA number.
3. Return the light without battery to:
Princeton Tec, PO Box 8057 Trenton NJ
08650. Postage due and freight collect
items will not be accepted.
4. Upon receipt your light will be processed
in about two weeks. Please allow
additional time for return transportation
from NJ.
Princeton Tec
PO Box 8057,
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
princetontec.com
© 2017 Princeton Tec
041
7
1. Battery Replacement
Remplacement des piles
Batteriewechsel
2. Operation
Modes de fonctionnement
Schalterbetätigung
1
1
2
2
3
