Princess 332950, Manual

Page: 10 / 64

10
EN
Mounting and removing the
accessories (fig. A)
Mounting and removing the suction
nozzle (fig. A)
The suction nozzle (13) can be mounted to
the extension tube (10).
To mount the suction nozzle, insert the •
extension tube (10) into the suction nozzle
(13).
To remove the suction nozzle, pull the
•
extension tube (10) from the suction
nozzle (13).
Mounting and removing the crevice
nozzle (fig. A)
The crevice nozzle (17) can be used for
vacuuming in narrow and hard-to-reach places.
The crevice nozzle (17) can be mounted to the
hose (7) or to the extension tube (10).
To mount the crevice nozzle to the hose, •
insert the hose (7) into the crevice nozzle
(17).
To mount the crevice nozzle to the
•
extension tube, insert the extension tube
(10) into the crevice nozzle (17).
To remove the crevice nozzle, pull the
•
crevice nozzle (17) from the hose (7) or the
extension tube (10).
Use
Unwinding and rewinding the
mains cable (fig. A)
The mains cable rewind button (2) can be
operated by hand or foot.
Before you proceed, we would like you to
focus your attention on the following notes:
- Do not unwind or rewind the mains cable
while the appliance is switched on.
- Always hold the mains plug to unwind the
mains cable. Never pull the mains cable.
Before use, hold the mains plug and •
unwind a sufficient length of the mains
cable from the back of the appliance.
After use, press the mains cable rewind •
button (2) to rewind the mains cable back
into the appliance. Manually guide the
mains cable to make sure that it does not
swing back. Make sure that the mains plug
is correctly located.
Adjusting the length of the tube
(fig. A)
Keep the locking knob (11) pressed and •
slide the extension tube (10) to the
required position.
Release the locking knob (11).
•
Adjusting the suction nozzle (fig. A)
The floor surface selector can be set to adjust
the suction nozzle to the required floor
surface. The floor surface selector can be
operated by hand or foot.
For vacuuming on laminates, tiles, etc., •
press the corresponding part (A) of the
floor surface selector (14).
For vacuuming on carpets, press the
•
corresponding part (B) of the floor surface
selector (14).
Switching on and off (fig. A)
The on/off button can be operated by hand
or foot.
To switch on the appliance, press the •
on/off button (1).
To switch off the appliance, press the
•
on/off button (1) again.
Adjusting the suction force (fig. A)
The speed control button can be used to
adjust the suction force.
Set the speed control button (1) to the •
required position:
- For vacuuming on hard surfaces
(e.g. floors), set a high suction force.
- For vacuuming on soft surfaces (e.g.
upholstery), set a low suction force.
Adjusting the airflow (fig. A)
The airflow can be adjusted using the airflow
control switch.
To adjust the airflow, set the airflow •
control switch (12) to the required
position.