Princess 332927, Manual

Page: 13 / 72

13
EN
Adjusting the suction force (fig. A)
The speed control button can be used to
adjust the suction force.
Set the speed control button (3) to the •
required position:
- For vacuuming on hard surfaces
(e.g. floors), set a high suction force.
- For vacuuming on soft surfaces
(e.g. upholstery), set a low suction force.
Adjusting the airflow (fig. A)
The airflow can be adjusted using the airflow
control switch.
To adjust the airflow, set the airflow control •
switch (11) to the required position.
Cleaning and maintenance
Before you proceed, we need you to pay
attention to the following notes:
- Before cleaning or maintenance, remove
the mains plug from the wall socket and
wait until the appliance has cooled down.
- Do not immerse the appliance in water or
any other liquids for cleaning.
Before you proceed, we would like you to
focus your attention on the following notes:
- Do not use aggressive or abrasive cleaning
agents to clean the appliance.
- Do not use sharp objects to clean the
appliance.
Regularly check the appliance for possible •
damage.
Regularly clean the ventilation slots using
•
a soft brush.
Store the appliance in a dry place, out of
•
the reach of children.
Replacing the dustbag (fig. B - D)
The dustbag (24) must be replaced when the
bag-full indicator (4) comes on. Replacement
dustbags are available from our service
station. If you have questions regarding the
dustbag, contact the service station.
To remove the full dustbag (24), refer to •
the section ”Mounting and removing the
dustbag”.
To mount the empty dustbag (24), refer to
•
the section ”Mounting and removing the
dustbag”.
Cleaning and replacing the motor
filter (fig. B - E)
Before you proceed, we would like you to
focus your attention on the following notes:
- Do not wash or rinse the motor filter.
The motor filter (28) reduces the amount of
dust entering the motor unit to a minimum.
The motor filter must be cleaned regularly.
The motor filter must be replaced after several
months or whenever worn or damaged.
Replacement motor filters are available from
our service station.
Keep the release button (7) pressed and •
open the cover (22).
If necessary, remove the dustbag (24).
•
Refer to the section ”Mounting and
removing the dustbag”.
Remove the filter (28) from the filter
•
holder (29).
Remove the dust from the filter using a soft
•
brush. If the filter is worn, use a new filter.
Insert the filter (28) into the filter holder (29).
•
If necessary, mount the dustbag (24). •
Refer to the section ”Mounting and
removing the dustbag”.
Close the cover (22) until the release
•
button (7) clicks into place.
Cleaning and replacing the outlet
filter (fig. F)
Before you proceed, we would like you to
focus your attention on the following notes:
- Do not wash or rinse the outlet filter.
The outlet filter (32) reduces the amount of
dust entering the motor unit to a minimum.
The outlet filter must be cleaned regularly.
The outlet filter must be replaced after several
months or whenever worn or damaged.
Replacement outlet filters are available from
our service station.
Press the tabs (30) and remove the cover •
(31).
Remove the wind outlet filter (32).
•
Remove the outlet filter (33) from the filter •
holder (34).
Remove the dust from the filter using a soft
•
brush. If the filter is worn, use a new filter.