EN
Hints for use (fig. A - D)
•
Place the appliance on a stable, flat and
heat-resistant floor.
• Remove the water reservoir (10) from the
appliance. Fill the water reservoir (10) with
the required amount of water. Place the
water reservoir (10) into the appliance.
• Hang the steam head (4) onto the steam
head holder (5).
• Insert the mains plug into the wall socket.
• To switch on the appliance, turn the on/off
switch (1) clockwise. The on/off indicator (1)
comes on. The appliance starts heating.
Note:
Keep the steam head (4) on the steam
head holder (5) during the heat-up process.
• Wait for approximately 45 seconds until the
steam head (4) starts emitting steam. The
appliance is ready for use.
• Remove the steam head (4) from the steam
head holder (5) with the steam vents pointing
away from you.
• Hang the garment on the clothes hanger
(14).
• Hold the steam head (4) with the steam
vents pointing away from you.
• Lightly touch the garment with the steam
head (4). Move the steam head (4) in a
vertical direction, starting at the top of the
garment and gradually moving downwards
(fig. D).
Note:
The appliance may make a gurgling
sound during use, which is a normal result of
condensation. If a gurgling sound occurs, hold
the steam hose (2) in an upright position to
drain the excess moisture back into the water
reservoir.
• If necessary, add more water into the water
reservoir (10).
• If the process is completed, remove the
garment from the clothes hanger (14) and
hang the steam head (4) on the steam
head holder (5).
• To switch off the appliance, turn the on/off
switch (1) counterclockwise. The on/off
indicator (1) goes off. The steam head (4)
stops emitting steam.
• Remove the mains plug from the wall
socket.
• Allow the appliance to cool down
completely.
Accessories (fig. A & E)
Fabric brush (fig. E)
The fabric brush (15) is used to open the
weave of the fabric for better steam
penetration.
Before you proceed, we need you to pay attention
to the following notes:
- Before mounting the accessory, switch off
the appliance, remove the mains plug from
the wall socket and wait until the appliance
has cooled down.
• Mount the fabric brush (15) to the steam
head (4) by aligning the bottom of the fabric
brush with the bottom of the steam head.
Gently push the top of the fabric brush (15)
on the steam head (4) until it clicks into
place.
• Gently brush the area to be steamed with
the grain or nap of the fabric.
• Move the steam head (4) in a vertical direction,
starting at the top of the garment and
gradually moving downwards.
• Remove the fabric brush (15) from the
steam head (4) by pressing the tab (21)
and pulling the fabric brush (15) forward.
Cleaning and maintenance
Before you proceed, we need you to pay
attention to the following notes:
- Before cleaning or maintenance, remove
the mains plug from the wall socket and
wait until the appliance has cooled down.
- Do not immerse the appliance in water or
any other liquids.
Before you proceed, we would like you to
focus your attention on the following notes:
- Do not use aggressive or abrasive cleaning
agents to clean the appliance.
- Do not use sharp objects to clean the
appliance.
• Regularly check the appliance for possible
damage.
• Regularly check the water reservoir for
possible leakage.
6