EN
Congratulations!
You have purchased a Princess product. Our aim
is to provide quality products with a tasteful
design and at an affordable price. We hope
that you will enjoy this product for many years.
Description (fig. A)
Your 332834 Princess garment steamer has
been designed for steaming garments and
fabrics to remove creases. The appliance is
suitable for indoor use only. The appliance is
suitable for domestic use only.
1. On/off switch / On/off indicator
2. Steam hose
3. Steam hose connection
4. Steam head
5. Steam head holder
6. Telescopic pole
7. Pole connection
8. Locking knob (telescopic pole)
9. Clamps (telescopic pole)
10. Water reservoir
11. Water filling point
12. Water drain point
13. Wheels
14. Clothes hanger
15. Fabric brush
Initial use
• Clean the appliance. Refer to the section
”Cleaning and maintenance”.
Assembly (fig. A)
Before you proceed, we need you to pay attention
to the following notes:
- Before assembly, switch off the appliance and
remove the mains plug from the wall socket.
- Make sure that the telescopic pole is fully
extended to provide a free flow of steam.
• Place the water reservoir (10) into the
appliance.
• Insert the telescopic pole (6) into the pole
connection (7). Turn the locking knob (8)
clockwise to lock the telescopic pole (6).
• Release the clamps (9). Set the telescopic
pole (6) to the maximum height. Lock the
clamps (9).
• Mount the steam head holder (5) to the
telescopic pole (6).
• Tighten the steam hose (2) onto the steam
hose connection (3).
• Hang the steam head (4) onto the steam
head holder (5).
Assembling the clothes hanger (fig.
B)
• Hold the clothes hanger (14) as shown and
insert it into the steam head holder (5).
Press the hook (16) into the steam head
holder (5).
• Pull the arms (17) outwards until the poles
(18) are in line with each other.
•
Push the fixed pipe (19) onto the pole (18)
until it locks into place.
Use
Filling the water reservoir (fig. C)
Before you proceed, we need you to pay attention
to the following notes:
- Before filling the water reservoir, switch off
the appliance and remove the mains plug
from the wall socket.
Before you proceed, we would like you to
focus your attention on the following notes:
- Do not use the appliance without water
in the water reservoir.
- It is recommended to fill the water reservoir
with a mixture of 50% tap water and
50% distilled water in order to prevent the
formation of excessive limescale.
- Only use cold water to fill the water reservoir.
- Do not use carbonated water or other liquids
to fill the water reservoir.
• Remove the water reservoir (10) from the
appliance.
• Remove the cap (20).
• Fill the water reservoir (10) through the
water filling point (11) with the required
amount of water.
• Mount the cap (20).
• Place the water reservoir (10) into the
appliance.
5