2. Press and hold the
SET POINT
button then
press and hold the
PRINCE CASTLE
button for 6
seconds. The LED indicator next to
PROG
will
light to indicate the Program Mode is active.
3. Use the
UP
and
DOWN
arrow buttons to in-
crease or decrease the setpoint temperature.
4. Press the
SET POINT
button to end the Program
Mode and store the setpoint temperature value
(the LED next to
PROG
will turn off). The con-
troller will regulate to the new setpoint tempera-
ture.
5. Repeat Steps 1-4 for remaining heaters.
Programming Timers
1. Press and hold the
PROG
button for 6 seconds.
All six timer displays will change to show
Prog.
2. Press the timer button to change. The timer
button LED will change to yellow and the current
programmed time is displayed.
3. Press the
UP
or
DOWN
arrow buttons to set the
time. Time values below 60 minutes will cause
the
M:S
led to light, and time values equal to or
greater than one hour will cause the
H:M
led to
light.
4. Repeat steps 2 and 3 for other timers. Press the
PROG
button to store the new values and end
the Program Mode.
545-502revB
3
Printed i
n
USA 1/06 © 2006
