Printed in USA 3/06 © 2006
2
340-506-EN
Universal Rapid Toaster
340-TCE
Safety Information
Indicates information important to the proper operation of
the unit. Failure to observe may result in damage to the
equipment and/or severe bodily injury or death.
Indicates information important to the operation of the unit.
Failure to observe may result in damage to the equipment.
WARNING
CAUTION
Important
Prince Castle reserves the right to change specifications
and product design without notice. Such revisions do not
entitle the buyer to corresponding changes, improvements,
additions or replacements for previously purchased
equipment.
Installation
Remove the unit from the carton and inspect for signs
of damage. If there is damage to the unit:
• Notify the carrier within 24 hours of delivery,
• Save carton and packaging materials for inspection
purposes,
• Contact your local dealer, or if purchased directly, the
Prince Castle Sales Department at 1-800-722-7853
or 630-462-8800 to arrange for a replacement unit.
1
NOTE: When installing this unit, the ambient
temperature at the mounting site should not exceed
37.8°C (100°F).
Your toaster may consist of one Universal Rapid
Toaster unit or two units positioned together to perform
as an assembly. Single units must be assembled with
a Buffered Bun Landing Zone (BBLZ) only. Two-unit
assemblies must be equipped with a BBLZ and a bun
chute that carries the product from the rear unit to the
BBLZ.
2
A. For two-unit installations, designate one unit to be
the “front” chamber. Orient the chamber(s) so that
the Club Section is positioned closer or farther from
the loader’s workstation — most stores prefer the
Club Section closer, but the URT is designed to be
configured either way.
B. Slide the BBLZ into the single unit or front chamber
of a two-unit assembly by pushing the BBLZ into the
unit from the front towards the back.
3
Push the BBLZ about halfway into position and
connect the wire assembly from underneath the BBLZ
to the connector on the base of the unit. This
connection provides power to heat the BBLZ.
Wire Assembly Under BBLZ
4
