100646 PUBLICATION DATE Sep 05
INSTALLATION AND MAINTENANCE MANUAL
21
REPLACEMENT OF DOOR RUBBER
MACHINES 6kg / 13lb, 7kg / 16lb, 10kg / 22lb
1. Open the door. Remove the door glass (Fig. 5.2.A, pos.3) with rubber (pos.2) from the stainless steel door
(pos.5) by pushing it towards the drum. Do it carefully, do not damage the glass.
2. Remove the seal (pos.4) from the glass.
3. Place a new rubber seal with wider groove on the glass with the edge up.
4. Moisten the seal groove (pos.2) for door with soap water. Place a smooth cord in the groove all around.
Tighten up the margin by cord and fit the unit to the door opening (pos.5) (with the clip up). Hold one end
of the cord firmly on the door. Pull the other cord end towards the center of the glass for the rubber edge
properly fit in.
ADJUSTING OF VIBRATION SWITCH
WARNING!
MAKE SURE THE MACHINE IS DISCONNECTED FROM POWER SUPPLY BY PULLING OUT THE PLUG!
The vibration switch is an important safety element which must - if correctly adjusted - stop the machine
if excessive vibrations and shaking occur due to an unbalance caused by improper distribution of linen
in the washing drum. It is recommended that at the first installation and then once in a year a qualified worker
verifies the vibration switch, fig. 5.2.C.
5. Dismantle (6kg / 13lb, 7kg / 16lb, 10kg / 22lb) the top cover by two bolts on machine rear for machines.
For the 16kg / 36lb the top cover can be folded open and supported by the support at the right side panel.
6. Check the distance between microswitch (pos 1) and the limiter (pos 2).
7. The distance between the microswitch and the spring holder must be 0,2mm / 0.008“.
8. Check the position and condition of the sensor (pos.3) in the limiter (pos 2).
It must be exactly in the center of the hole! Unscrew the tiltswitch plate and move the plate up, down, left
and right to adjust the center of the sensor to the center of the hole on the limiter.
9. At the first installation and then once in a year the vibration switch has to be tested on his functionality.
After starting the extraction mode and after reaching the maximum RPM, carefully switch over the vibration
switch by moving the flexible sensor manually. The machine will stop extracting and will return to 0 RPM.
WARNING!
DO NOT OPERATE THE MACHINE IF THIS FUNCTION DOESN’T WORK ANYMORE!
DO THIS CAREFULLY TO AVOID INJURIES BY VIBRATING AND FIRM PARTS OF THE MACHINE!
AFTER YOU HAVE CHECKED THE FUNCTION, MOUNT THE MACHINE COVER BACK!
1. Microswitch
2. Limiter
3. Sensor
Fig. 5.2.C. Vibration switch
!
!