www.primusaustralia.com.au • Sales: 1300 555 197
Q: Will direct shade affect the power output of the solar panel?
A: Yes, locate the panel in direct sunlight for maximum output.
Q: Will my solar panel work in cloudy conditions?
A: Yes, the solar panel will work in low light conditions however the
power output will be reduced as there is less energy collected.
Q: Should I clean my solar panel?
A: Yes, removing dust, dirt, bird droppings, etc with warm soapy
water will assist with the solar panels energy collecting
performance
Q: How do I clean the power pack?
A: Use a mix of warm soapy water, do not use bleach or harsh
cleaning chemicals and carefully wipe down all surfaces
avoiding water entering the power pack.
Q: Can I replace the LED’s?
A: No, the LED light has a life expectance of 8,000 hours of
continuous
operation.
Suggestions for safe and secure use
Failure to follow these complete instructions and the
suggestions below may cause system damage and/
or personal Injury.
•
This controller is only designed for 12V solar charging.
• The built-in electronic circuit protector keeps the controller away
from overcharging, overfl owing, overloading and short-circuit.
• Sealed, maintenance free VLRA batteries are highly
recommended.
• The controller will heat up during use, place in a well-ventilated
location and avoid contact with the controller surface.
• Keep the ventilation holes on the controller free of dust
and
debris.
• The battery may produce fl ammable gases, please keep
away from spark or open fl ame, ensure the battery is kept in
a well-ventilated location.
• Fully charge the battery at least once a month.
• Do not contact or short circuit the terminals or wires.
• Please use insulated tools during operation, keep both hands
dry and do not stand on the wet ground.
• Please follow the security recommendations from the battery
manufacturer. Contact the distributor or the installation
personnel if there is any doubt.
General Disclaimer
In no event shall the manufacturer be liable for any damage or personal
injury caused by non-compliance to the operating instructions and safety
suggestions in this brochure. The manufacturer will not bear any
responsibility for misuse, damage, injury, incorrect installation and/or
system design as such.
Frequently asked questions
NORMAL VOLTAGE
12V
MAX. CHARGING CURRENT/LOAD CURRENT
≤
1A
CURRENT NATURAL LOSS
≤
5mA
SOLAR MODULE
STC Power
5W
Operating Voltage (Vmp)
17V
Operating Current (Imp)
0.29A
Open Circuit Voltage (Voc)
21.6V
Short Circuit Voltage (Ics)
0.34A
BATTERY
Battery Type
Maintenance Free
Lead - acid battery
Capacity
12V/5.0AH
DC LAMP
Light Source
12 Super
Bright LED
Rate Power
0.6W
Rate Voltage
12V
Rate Current
50mA
Luminosity
50Lum
CHARGING TIME
(SOLAR)
Approx. 8 to 10 hours in full sunlight when the
battery is fully discharged
OPERATING TIME
1 lamp
66 Hours
4 lamps
16 Hours
OPERATING TEMPERATURE RANGE
-10~60°C
(-40~122°F)
SPECIFICATIONS
Please note: Specifi cations may change without notice
Troubleshooting and maintenance
TROUBLES
POSSIBLE CAUSES
CORRECTIVE MEASURES
ORANGE LED
IS NOT
ILLUMINATED
WHEN SOLAR
PANEL IS
CONNECTED
POWER PACK ON/OFF
BUTTON IS NOT SET
PRESS BUTTON TO
“ON” POSITION
SOLAR PANEL IS
NOT CONNECTED
CORRECTLY
CONNECT TO POWER PACK
SOLAR PANEL NOT
EXPOSED TO THE SUN
LOCATE IN DIRECT
SUN LIGHT
LED LIGHTS
WILL NOT
OPERATE
POWER PACK ON/OFF
BUTTON IS NOT SET
PRESS BUTTON TO
“ON” POSITION
RED LED IS
ON / POWER PACK
IS FLAT
CHECK CONNECTIONS
AND SWITCHES ARE IN
ON POSITION
CHARGE POWER PACK
LED LIGHTS
OPERATE FOR
A SHORT
TIME ONLY
RED LED IS ON -
POWER PACK IS LOW
IN VOLTAGE
LOCATE SOLAR PANEL IN
DIRECT SUNLIGHT FOR
MINIMUM OF 8 HOURS
CHECK CONNECTIONS
AND SWITCHES
POWER PACK
WILL NOT
CHARGE
POWER PACK ON/OFF
BUTTON IS NOT SET
PRESS BUTTON TO
“ON” POSITION
CHECK POWER
PACK CONDITION
IF FAULTY -
REPLACE BATTERY
CHECK SOLAR
PANEL OUTPUT
IF FAULTY - CONTACT
MANUFACTURER
PRI6578
