Cleaning
Periodic dust removal is necessary to maintain light intensity and quality.
Caution:
Never open the Fresnel fixture unless the unit has thoroughly cooled.
Never touch the LED diodes even when cool as skin oils will cause damage.
Caution:
disconnect power to the fixture before opening.
The lensed bezel will swing open by loosening the 1/4” Allen bolt opposite the hinge. This will
expose the heat sink and the LED Cluster. Low pressure compressed air, not canned Freon is best for
dust removal. A feather duster is acceptable if not used too vigorously. Small quantities of Isopropyl
alcohol is the only acceptable cleaning agent, when applied by a soft cotton cloth. DO NOT touch or
use a cleaning agent on the diodes.
Caution:
Again, make sure that the fixture is cool and electrically disconnected as isopropyl alcohol
is highly flammable. When cleaning is complete, make sure the fixture is dry and mechanically
closed and fastened before applying power.
Safety Precautions
Caution: Never look directly the light source
One of the premier features of the GUS 51 is that it is thoroughly passive in the rejection of heat. No
fans or other mechanical devices are needed to insure that no damage occurs due to over heating.
This product was designed from scratch as an LED Fresnel not an adaptation of an old incandescent
model. The robustness of the heat sink and the design of the external housing, along with several
proprietary design features, insures that the luminaire will not over heat in ambient air as hot as 120
degrees F. Continuous operation in ambient air in excess of 120 dgr . F (49 dgr. C) is not advisable.
Man
ufactured in the USA by:
PrimeTime Lighting Systems, Inc. •
4124 Billy Mitchell Dr.
•
Addis
on, TX 7500
1
(214)-393-5998
PrimeTimeLighting.com
10529 Olympic Drive • Dallas, TX 75220 • ofc 214.393.5998 • fax 214.393.5999
PrimeTimeLighting.com
10529 Olympic Drive • Dallas, TX 75220 • ofc 214.393.5998 • fax 214.393.5999
