35,0(6
Cube
27
Revision 01/2019 EN
1.
Observe the safety instructions in chapter 13.1.1, „Safety instructions“, on
page 26.
2.
Unscrew the 4 Torx screws M2.5 x 6 mm on the protective window holder.
3.
Place the device as shown in Fig. 13.1 on page 27 and carefully remove the
protective window holder upwards.
•
Make sure that the inserted O-ring does not fall out of the device.
4.
Remove the old protective window from the device and dispose it.
5.
Wear cotton or powder-free latex gloves and insert new protective window into
the device.
•
Ensure that the inserted O-ring is not out of place.
6.
Place the protective window holder according to Fig. 13.1 on page 27.
7.
Tighten the protective window holder with 4 Torx screws M2.5 x 6 mm.
8.
Check for secure fit of the protective window holder:
•
The protective window holder must lie flat against the device.
Torx screws
M2.5 x 6 mm
Protective win-
dow holder
Protective window
O-ring
Fig. 13.1: Exchanging the protective window on the Cube
