30
2G Adjusting the Gap Sensor Position (Pre Die-Cut Labels Only)
If you are using label stock other than standard square / rectangular die-cut labels such as circular
die-cut labels or through-hole stock use the instructions below to adjust the position of the label
stock gap sensor. The sensor can be adjusted using the slide bar on the back of the printer. Below
the slide bar is a measurement which represents the distance between the edge of the label stock
and the sensor. Measure the distance from the edge of the label stock to the correct position on the
stock. Set the sensor so the side of the slide bar lines up to this measurement. See dashed line in the
illustration below.
Circular Labels
If you are using Circular Labels you must adjust the stock sensor to correspond with the very top of
the label where the circles are closest together. If the sensor is too far to the right or the left the
printer will still sense the label but the image may be offset downward because the printer will start
printing at the wrong position. If you are using stock that has multiple labels across, make sure the
sensor corresponds to a place on the stock that has a label and not a vertical gap
Important Note
: You must adjust the stock sensor
before loading nonstandard label stock.
