Primera DX850e, Quick Start Manual

Page: 6 / 16

6. Now position the stock to correspond with the general area where the labels will be
dispensed.
7. Pull the loose end of the label stock forwar d under the Top Roller. Pull approximately
6 inches of label stock out beyond the Peel Edge.
(Figure 2-5.)
8. Take the loose label stock and feed it between the Liner Idler Roller and the Liner Drive
Roller.
(Figure 2-6.)
In order to feed the label stock between the r ollers, the Liner Idler
Roller should be in the unclamped position.
(See Figure 2-10 for a detailed diagram of the
Liner Idler Roller positions.)
Note:
This procedure assumes that the first 6 inches of labels will not be dispensed using the Label
Dispenser. Of course, you may still peel these labels by hand.
6 DX850e Label Dispenser
Figure 2-6.
Figure 2-5.
Tip! See Section 5 for
a Label Path diagram.