TWINDOSE 20
Rev. 1.4
cod. 0000136325
3
1.4
WARNINGS
Check pressure at the rinse injection point in respect of the max-recommended
pressure for the rinse pump.
Check suction tubes are inserted in the correct product tanks (supply containers).
All electrical connections to the TWINDOSE 20 should first be verified with a meter.
Application of incorrect voltage will permanently damage the unit and is not covered
under warranty. Avoid wiring to any power source that has large fluctuations in voltage
and/or is prone to surges. Refer to the wiring diagram in this manual for all power and
signal connections.
Check the voltage of the main power source and make sure that it matches one of
the three available input voltages (24 - 115 - 230 Vac) of the transformer inside the
TWINDOSE 20.
CAUTION: The TWINDOSE 20 has high voltage connected to the transformer. Always
disconnect power when servicing the unit.
CAUTION: During installation and electrical connections remove all power from the
warewasher.
Non-compliance to any of the dispositions hereby contained may cause damage to
persons or things or the incorrect functioning and damage to parts of the equipment.
GETTING
STARTED
Installation
Set Up &
Operation
Maintenance &
Accessories
Troubleshooting
Contacting SEKO
