TWINDOSE 20
Rev. 1.4
cod. 0000136325
2
1
GETTING STARTED
1.1
WELCOME
Get ready for a whole new experience.
TWINDOSE 20
has a fresh, new look and it’s easier than
ever to use.
The
TWINDOSE 20
dispenser was designed to dispense warewashing chemicals to door and
conveyor-type warewashing machines by using an advanced technology to meter precise
amounts of product to the warewasher. Independent electronic circuit boards control all injection
of products that are delivered to the wash tank via peristaltic pump. Injection control is set with
DIP switches.
This book explains how to get
TWINDOSE 20
set up and where to turn for help, so you can enjoy
the most intuitive dosing system yet.
Please review this manual carefully. Pay particular attention to warnings and
precautions. Always follow good safety procedures, including the use of proper clothing,
eye and face protection.
Please be sure to read entire manual and select operating mode before installation.
1.2
WAT’S IN THE BOX
Before you start, check that your box contains the following items:
System enclosure with entire peristaltic pump on board;
Foot filter (2);
Detergent Injector (1)
Non Return Injection Valve (Rinse) (1);
2-wire cable, 2x1.5 type H-05 VVF 3mt.
Inlet and outlet tubing
Jumpers (2)
1.3
FEATURES
Power Supply: 24 115-230 Vac 50/60 Hz
Power Consumption: 8 W
Detergent Pump Flow rate: 1 … 6 l/h
Rinse Pump Flow rate: 0. 18 … 1 l/h at 3 bar
Protection of the System: IP65. The gasketed enclosure on the
TWINDOSE 20
is highly water
resistant and the electronics are further protected within the enclosure
Weight: 3 kg
Dimensions: L 195 P 110 H 168 mm
GETTING
STARTED
Installation
Set Up &
Operation
Maintenance &
Accessories
Troubleshooting
Contacting SEKO
