Prime Water Prime LC-11, User Manual

Page: 7 / 16

12 13
Installation Direct to Cold Water Line Operation Method
Find the cold water supply
line and close the valve. Disconnect the cold water
hose from the line. Make
sure it is the cold water hose
and not hot because hot
water will cause the unit to
malfunction.
Connect the cold water line
adapter to the cold water
supply valve as shown.
As fittings vary you will need
to find the right size adaptors
at your local plumbing store. Connect the plastic tubing
as shown. Connect hoses to the water
inlet and acidic water outlet
then open the cold water
supply valve.
Separate the water line.
1
4
2 3
6 5
Be sure the valves are all connected tightly to prevent leakage.
Be sure of where you want to install the ionizer as a hole needs to be drilled through the sink top to thread the tube.
Be sure you connect the unit to cold water as hot water can damage the unit.
This is a good time to double check and make sure all your fittings are tight and the tubing is secure in the fittings.
Check daily for any leaks during the first week after installation and check for leaks occasionally thereafter.
CAUTION
Alkaline Water discharge method
Acidic Water discharge method
Purified Water discharge method
Press the “ON/OFF” button and then select the
“ALKALINE” button and tap until the desired Alkaline
level displays on the screen.
The level indicator will display the level you selected.
To STOP collecting water, press the “ON/OFF” button.
Press the “ON/OFF” button and then select the
“ACIDIC” button and tap until the desired Acidic
level displays on the screen.
The level indicator will display the level you selected.
To STOP collecting water, press the “ON/OFF” button.
Press the “ON/OFF” button and then select the
“PURIFIED” button to start dispensing filtered,
Purifed water.
To STOP collecting water, press the “ON/OFF” button.