Distributed by Primal Vantage Company Inc. 685 Route 10 East, Randolph, NJ 07869
7. After the ladder stand has been secured to the tree with the
installation straps, and the stabilizer bar has been securely attached to
the tree, continue to have two people hold the ladder, climb cautiously
up to the platform.
Once you reach the top,
IMMEDIATELY ATTACH YOUR SAFETY
HARNESS TO THE TREE.
Keep the tether strap above your head.
NOTE:
Drawings are for illustration purposes only and may not depict actual product.
ASSEMBLY INSTRUCTIONS PAGE 2
MODEL: HEH00595
20” REPLACEMENT LADDER
CUSTOMER SERVICE DEPARTMENT 1-866-972-6168
©2012 (rev. 04/12)
WWW.TREESTANDCUSTOMERSERVICE.COM
STRAP INSTALLATION
3
Pull Strap to tighten
Hold Strap as shown
1
Insert Strap through looped end
2
Use these same instructions to attach the buckle
Pull strap to desired length.
Hold buckle as shown
Press down on latch and insert
strap underneath teeth as shown.
Pull slack to tighten.
4
BUCKLE INSTRUCTIONS
6. Re-attach Buckle Strap just behind the brace
of the inner part of Stabilizer Bar by following
the Strap Installation below.
(See Strap Installation below)
Position the Stabilizer Bar against the tree and
secure it by wrapping the strap around the back
of the tree once and insert the strap into the
buckle.
(See Buckle Instructions Below)
WARNING
DO NOT
climb ladder without stabilizer bar
installed. Serious injury or death may occur if
stabilizer bar is not installed.
WARNING
Stabilizer Bar and Installation Straps
MUST
be secured prior to climbing the
Ladderstand. Failure to comply may
result in serious injury or death.
