installation instructions - 70cm
step 4: secure appliance into housing unit
Note: The unit housing the appliance must
be appropriately fixed.
Method 1:
Care must be taken to ensure
the appliance runners are sufficiently
engaged over the top of the runners on
the base units.
Method 2:
Insert appliance into cabinet
- ensure that it is engaged over the top of
the side runners.
Method 3:
Insert appliance into cabinet.
to secure appliance to housing unit
Note:
Ensure that the appliance is centrally
located. Take care not to damage the
appliance or cabinet.
Note:
For installation
Method 1
, you will
need to drill through the fixing holes into
the side trims with a 3.2mm diameter drill.
There are 6 securing screws.
■
Open the grill / top oven door, and
screw 2 screws through the top corner
holes in the front frame.
■
With the grill / top oven door still
open, screw 2 screws through the
holes in the front frame, located under
the grill compartment.
Close the grill / top oven door.
■
Open the main oven door, and screw
the remaining 2 screws through the
bottom corner holes in the front frame.
Close the main oven door.
installing a hob above the appliance
When the appliance is installed under a
worktop, with a hob installed above it,
the installation instructions for the hob
must be read in conjunction with these
instructions.
When installing a gas hob above the
appliance, care must be taken to ensure
that the hob inlet pipe is as close to the
back wall as possible, so that it does not
obstruct the appliance or the appliance
inlet pipe.
If a flexible inlet pipe is used, it must hang
vertically and not be trapped between the
oven and rear wall.
Important:
- ensure that you route all
mains and electrical cables and flexible
tubing well clear of any adjacent heat
source, such as an oven, grill or hob.
Summary of Contents for LPR808
Page 39: ......
