30
Victory Viper-3/Rev A/May 2003
www.pridemobility.com
V I I . C O M F O R T A D J U S T M E N T S
SEAT HEIGHT ADJUSTMENT
To reposition the seat to one of three different
heights:
1. Remove the seat from your scooter. Push down
and hold the seat lock lever to unlock the seat,
then rotate the seat and lift it off of the scooter.
2. Remove the rear shroud.
3. Use two 17-mm spanners to loosen and remove
the hex head bolt and nut. See figure 18.
4. Raise or lower the seat post to the desired seat
height.
5. Hold the seat post at that height and match up
the locating holes in the seat post with the seat
post tower.
6. Reinstall the hardware and tighten.
7. Replace the rear shroud and the seat.
Figure 18. Seat Height Adjustment
SLIDING SEAT ADJUSTMENT
You can reposition the seat forward or rearward to adjust the distance between the seat and the tiller. To
reposition the seat:
1. Pull the seat sliding lever to the side. See figure 19.
2. Hold the lever to the side and slide the seat forward or rearward into a comfortable position.
3. Release the seat sliding lever to lock the seat securely in place.
SEAT ROTATION ADJUSTMENT
The seat lock lever locks the seat in one of eight positions. To rotate the seat:
1. Pull up on the seat lock lever to unlock the seat. See figure 19.
2. Rotate the seat to the desired position.
3. Release the seat lock lever to lock the seat securely in place. If the seat is not locked into position,
gently rock the seat back and forth until you hear the lever click.
SEATBACK ADJUSTMENT
To adjust the recline angle of the seat:
1. Pull up on the seat recline lever to unlock the seatback. See figure 19.
2. Lean forward or rearward to adjust the seatback to a comfortable position.
3. Release the seat recline lever to lock the seat securely in place.
WARNING! Always keep your back pressed firmly against the seatback while adjusting
the angle.
SEAT POST TOWER
SEAT POST
HEX HEAD BOLT
AND NUT
