Rival www.pridemobility.com 25
SETSCREW
CONTROLLER BRACKET
I V . C O M F O R T A D J U S T M E N T S
Figure 14. Controller Position
Controller Position
You can move the controller in toward or out away from the
armrest, or change the position of the controller for either
left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in the seat
frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket.
See figure
14.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector(s) from the power base.
3. Remove any wire ties securing the controller harness to
the armrest.
4. Flip up the armrest so it is perpendicular to the floor.
5. Loosen the setscrew on the controller bracket
6. Slide the controller out of the armrest.
7. Loosen the setscrew in the other armrest.
8. Place the controller in the other armrest.
9. Tighten the setscrews in both armrests.
10. Route the controller harness to the back of the power base
and plug in the controller.
11. Secure the controller harness to the armrest with wire
ties.
NOTE: If your power chair is equipped with a Specialty
Seat, Synergy Seat, or TRU-Balance Power Positioning
System, refer to the information provided in supplemental
manuals provided with your seating system.
Summary of Contents for Quantum Rival series
Page 38: ...38 www pridemobility com Rival N O T E S ...
Page 39: ......
