22
www.pridemobility.com
Quantum R-4000
I V . A S S E M B L Y
Seat Installation and Removal
Do not attempt to install or remove your seat. If your seat
needs to be removed and reinstalled, contact your Quan-
tum Rehab Dealer.
WARNING! Your seat should only be
installed or adjusted by a Quantum
Rehab Dealer.
NOTE: If your power chair is equipped with a Syn-
ergy Seat or a TRU-Balance 2 Power Positioning Sys-
tem, refer to the information provided in separate
manuals.
Controller Installation
It may be necessary to install your controller.
To install the controller:
1. Install the controller into one of the armrests. See V.
“Comfort Adjustments.”
2. Route the controller cable to the front of the power
base, ensuring the cable cannot be pinched in the seat
hinge. See figure 10.
3. Plug the controller cable into the connector. See figure 6.
4. Secure the controller cable to the armrest receiver with
wire ties if desired.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller
harness on the outside of the armrest
pad. Route the harness under the
armrest or toward the inside of the
armrest pad. Use correct tie-down
points for the controller harness to
prevent the harness from getting caught
in the drive tyres, pinched in the seat
frame or damaged when passing
through doorways.
Figure 10. Controller Cable Routing
