Pride CL10KD, Owner'S Manual, Page: 13 / 32

Lift Chair Series www.pridemobility.com 13
LIFT CHAIR SERIES
MASSAGE
UNIT
IV. ASSEMBLY/DISASSEMBLY
4.1.3 Push firmly on the top of the chair-back to lock
into position. Listen for a click on each side to
ensure the chair-back is locked in properly.
“CLICK”
4.1.5 For units equipped with heat and/or massage
options, connect the heat and/or massage har-
nesses to the junction box mounted to the back
of the lift chair. There will be one heat connec-
tion and two massage connections. Refer to
“Appendix C” for proper harness connections.
4.1.6 Attach the chair-back to the hook and loop
flaps on the bottom of the chair base.
4.1.4 Connect the hand control harness to the lift
chair. Refer to “Appendix B,” “Appendix C,”
or “Appendix D” for proper hand control
connections.
MASSAGE
UNIT
JUNCTION
BOX
NOTE: Unit LL450 will come equipped with two
heat pads; both heat pad harnesses will be
spliced to form a single harness that you can
connect to the junction box. Refer to “Appen-
dix C” for proper harness connections.
HEAT CONNECTION
TO JUNCTION BOX
NOTE: Pull up on the chair-back to ensure that
it is locked in place. If the back can be pulled
off, then repeat steps 4.1.1 and 4.1.3. You
must hear a click from each side of the chair.
WARNING! Do not connect the push-
button or heat/massage hand control
directly to the motor. Connect the hand
control directly to the junction box to
prevent equipment damage.