Pride Air, Owner'S Manual

Page: 13 / 32

Jazzy Air www.pridemobility.com 13
I I I . YO U R P O W E R C H A I R
NOTE: For more information on the Jazzy Air warning displays, refer to the basic operation instructions for
your controller.
The Jazzy Air feature should be used only on fl at, level, indoor surfaces, such as in malls, offi ces, and/or medical
facilities, and only on limited, fl at, level, hardscape, outdoor surfaces.
While the Jazzy Air feature is in use, the power chair can drive at a predetermined, safe speed. Refer to the
specifi cations table for more information on the reduction of the maximum speed.
PROHIBITED! Never use the Jazzy Air outdoors on uneven terrain (gravel, hills or other uneven,
non-compact terrain) or in fi elds.
WARNING! The Jazzy Air feature should be used only on fl at, level, indoor surfaces, such as
in malls, offi ces, and/or medical facilities. Never raise the seat from its lowest position on an
inclined surface. Failure to heed this warning can result in the power chair tipping over.
WARNING! The Jazzy Air feature is intended for limited outdoor use on only fl at, level, hardscape
surfaces. If you are unsure of your environment, do not use the Jazzy Air outdoors.
WARNING! Never raise the seat into Jazzy Air when operating your power chair on bumpy or
uneven surfaces. Failure to heed this warning can result in the power chair tipping over.
WARNING! Always fasten the positioning belt when operating the power chair.
WARNING! Do not operate the Jazzy Air or change the seat height in any way while your power
chair is positioned under a fi xed object, such as a table or desk. Keep area clear prior to and
during movement.
NOTE: The Jazzy Air feature is equipped with a system that allows the power chair to drive at a predetermined,
safe speed when the chair is elevated. Always check to be sure this system is operating properly before using
your power chair.
Marker lights
Your power chair is equipped with marker lights. The lights are composed of two white LEDs in the front and two
red LEDs in the rear and are mounted on the shroud of your power base.
See fi gure 1.
The marker lights operate through an on/off switch that is mounted to an armrest.
To operate the marker lights:
1. Press the on/off switch once to activate the marker lights.
2. Press the on/off switch again to deactivate the marker lights.
NOTE: Turn off marker lights when the power chair is not in used to optimize power chair performance per
charge.